Lamination Core Applications - Sino Lamination Core Manufacturer

Laminations don’t get bought for their own sake. They get bought because something has to spin, or hum, or hold a magnetic field steady for years. Here’s where our cores end up — and what each application asks of them.

Electric Vehicles & E-Mobility

Traction motors are the hardest case we see. High frequency, high current, and a buyer watching the range figure. That means thin steel — 0.20 mm and below — low core loss, and tolerances that survive high rpm. We run EV cores on high-speed stamping for volume, laser cutting for prototypes.

Industrial Motors & Drives

The bulk of the market, and the least forgiving on price. 50/60 Hz, continuous duty, IE3 to IE4 targets. Standard non-oriented silicon steel at 0.35 or 0.50 mm usually hits the number without overpaying for it.

HVAC, Fans & Air Movement

These motors run for years at part load. Nobody notices them until they get noisy. Balanced, quiet, low-vibration stacks matter more than a peak efficiency number that only shows up on a lab bench.

Power Generation

Big diameter, low speed, high pole count, and a service life measured in decades. Often segmented so they can actually be shipped and assembled on site. Wind, hydro, and standby gen-sets all land here.

Automotive & Aerospace Actuators

Highest power density, worst environment. 180–250 °C insulation systems, direct liquid cooling, and a paper trail behind every lot. Nobody here accepts “good enough” without evidence.

Motion Control, Robotics & Automation

Low cogging, tight pole placement, repeatable torque. Steppers and servos where a micron of misalignment eventually shows up in the finished part.

Transformers, Inductors & Power Electronics

Grain-oriented steel with a closed flux path. EI and UI shapes, CRGO and CRNGO, plus high-permeability nickel-iron when the signal is small and the loss budget is smaller.

Small Motors, Tools & Appliances

High volume, cost-sensitive, and still expected to last. Good tooling and a stable stamping process are what carry this category — not fancy steel.

Tell us where yours goes

Send the drawing or the spec sheet. We’ll come back with the material, the thickness, the stack, and the price. And if a cheaper combination gets you the same result, we’ll tell you that instead.

Let Sino's Lamination Stacks Empower Your Project!